Následující příklady ukazují jak naši zákazníci úspěšně využívají  MAGMASOFT® k dosažení lepší kvality odlitků,  snížení nákladů nebo ke zkrácení doby přípravy.

Problem Corrected – Case Solved

An HPDC client in India who is a large manufacturer of motorcycles and scooters for both domestic and export markets, experienced porosity problems with a cast component from one of their suppliers after machining the casting on the top side.


Engine Blocks Full of Stress

Cast iron engine blocks can be found in more than half of all passenger cars. Their performance and weight are, among other criteria, dependent on their geometry and the casting process, especially defects like porosity and residual stresses.


Real Prototype – Realistic Casting?

Before start of production, many real castings are required for testing under realistic conditions. As with many of these prototype castings, the aluminum steering knuckle shown here was produced as a sand casting. The failure of the prototype casting in a test run would lead to design changes: heavier cross-sections to better withstand the load.


Small Changes Result in Big Improvement

The original gating system of a front fork component led to problems that were analyzed using MAGMASOFT®. The original design of the gating system of the front fork led to several problems that were detected by simulation.


Solving Casting Surface Defects

The surface of a die casting suffered from peeling or had two-tone discolorations. Sometimes a second buffing was required to eliminate these surface problems.

Tyto webové stránky používají soubory cookie k zajištění lepšího prohlížení. Ochrana osobních údajů