Gates Designed to Reduce Stress

Warping is a typical problem for die casters. During solidification and cooling, the casting can resist contraction of the gating system, leading to a build up of stresses in both the gating and casting. When the gating is trimmed, these stresses are rearranged and distortion of the casting can be the result.

Using the stress simulation technology of today, it is possible to design gating systems resulting in a minimal warping tendency. The two different layouts shown here both will lead to a proper filling of the casting, but very different stress distributions will result. In the layout with two gates, the residual stresses extend from the gate into the casting before trimming. After the gate is removed, these stresses are relieved and distortion results.

In the second case, the residual stresses are much more confined to the gating and a lowered tendency to warpage after trimming is the result.

Stresses are present in gating and casting before trimming (left) and stresses are relaxed after removing the gating (right)

Stresses are moved into the gating system in the new layout (left). Redistribution of stresses after trimming the gating lead to less distortion (right)

Tyto webové stránky používají soubory cookie k zajištění lepšího prohlížení. Ochrana osobních údajů