Přečtěte si níže ohlasy MAGMA uživatelů, jak dosáhli zlepšení pomocí simulace slévarenských procesů a optimalizace, v různých oblastech slévárenství.
Re-Engineering the Past with Modern Technology
Re-engineering a historical steam locomotive is a real challenge. The British foundry Boro was asked to cast a key component of the engine using its original design and manufacturing technique. Due to the optimization of the methoding with MAGMASOFT®, the casting was done right the first time.
více
Using Concurrent Engineering for Optimized Castings
Robust castings realized through a dialog between designers and foundry
více
Optimization of Steel Casting Design and Methoding
Hot tearing is one of the main defect sources in steel castings. However, the cost-intensive repair work created by this defect can be avoided by reviewing the influence of casting design and methoding on the formation of hot tears.
více
Methodical Assessment of Different Casting Layouts
At ZI in Bergzabern, Germany, the new virtual experimentation capabilities in MAGMA5 were recently used to make a successful comparison of different production alternatives for a gear housing.
více
Optimization for an Exhaust Manifold
Heunisch-Guss has been using MAGMA5 for years as part of its preventative quality management system, to ensure a timely analysis of casting layouts and possible defect sources.
více
Ingot Casting Optimization at Třinecké železárny
Třinecké železárny (TŽ) is a well-known producer of cast ingots. Reliable and stable production processes and high quality and cleanness of all products are constant requirements. Due to the continuously increasing demands for both, improved quality and, at the same time reduced costs, TŽ recently decided to revise and subsequently optimize their entire ingot casting line.
více
Chongqing Dajiang Millison Optimizes Die Casting Bracket Production
For Chongqing Dajiang Millison (CDM), the targets in production are clear: fast product development, reliable manufacturing processes and optimized product yield. These objectives apply for a great variety of cast parts.
více
DGS Produces One of the Largest Die Cast Parts Worldwide
Each hour, the sun radiates enough energy onto the earth to cover the annual energy demand of the whole world population. For better exploitation of this solar energy, DGS Druckguss Systeme AG, St. Gallen, Switzerland, produces frames for hot water solar panels. Recently, the production of these frames was changed from welded extrusion molded parts to aluminum die castings. The success of this change was so noteworthy that the new frame received a ”Special Recognition“ award in the International 2014 Aluminum Die Casting Competition.
více
MAN Copenhagen Reduces Residual Stresses in Diesel Engine Components
For MAN Diesel and Turbo (MDT), Copenhagen, understanding and controlling residual stress levels in their engine components is a crucial factor for an economical production. To successfully handle this task, MDT employs a sophisticated, effective and professional quality management system, ensuring part and component quality.
více
Surya TOTO: Taking an Unusual Approach
The Surya TOTO engineering division was recently challenged to cast something they had never produced before. Although cast components for thermostats are successfully produced using copper base alloys in the low pressure die casting process on a daily basis at Surya TOTO, this new model was significantly different.
více