Yield Improvement Using Optimization

A safety critical automotive part was produced without defects, but the foundry wanted to improve its yield. No changes in the casting design or the riser contact areas were allowed. Autonomous optimization in MAGMASOFT® was used to redesign risers on both sides of the castings, as well as the ingate and downsprue. First, the outside risers were given a large design window, allowing them to change their shape, size, distance to the casting and vertical location. Constraints were set to allow for sufficient clearance between the castings and the risers, as well as between neighboring risers. In a second step, the inside risers were optimized, but small changes in the outside risers were allowed to compensate for changes in the melt temperature distribution induced by the geometric changes.

Parameterized riser dimensions are basis for yield optimization

Finally, the design of the downsprue and ingates was optimized to guarantee the synchronous filling of all the castings, as well as to minimize the volume of the gating system.

The final design led to a reduction of 5.5 kg in pouring weight with unchanged pouring time or casting quality.

Parallel optimization of down runner, ingates and risers

Tyto webové stránky používají soubory cookie k zajištění lepšího prohlížení. Ochrana osobních údajů